Motherboard cooling tests
Cheaper, yet decent cases are not completely gone from the market yet. One such case is the Prime AP201 from Asus’ lower-end. Considering the price well under 100 EUR, you get a case with a above-standard build quality, which is characterized by the “infinite” perforation. Cool air is thus available to components theoretically from all sides. But this also means that it doesn’t damp noise too much. The question is what weighs more in the bigger picture.
Motherboard cooling tests
- Contents
- Exterior
- Interior
- Test methodology
- CPU and GPU cooling tests
- Motherboard cooling tests
- SSD cooling tests and under-ceiling temperature
- Conclusion
I am curious why adding two fans blowing air to the GPU worsened its temps. Perhaps it’s because the fans have to spin slower overall to achieve the same noise level? The bottom panel plus the filter do look quite restricted so the bottom fans might be providing fairly low airflow.
I like them applying the front PSU mount (more commonly seen in SFF cases) to mainstream cases though, it saves lots of space and airflow can still be great. 3 top fans exhausting air + flipping the CPU cooler to take air in from the back will likely lead to the best balance of CPU/GPU thermals when using air coolers.
The reason is probably quite simple. In a single-fan configuration, at equal noise levels, the fan on the exhaust is significantly faster than in a three-fan configuration. Not only the cooling of the graphics card, but the overall cooling (including the CPU, power delivery surroundings and SSD) is weaker probably due to more heat build-up when the fan on the exhaust is slower. This behaviour is quite typical and at equal noise levels, we usually measured a higher efficiency in a negative pressure configuration in this test of different system cooling configurations as well.